Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL DESCRIPTION OF THE
COMMAND TRANSMISSION UNIT
LOCATED ON THE TX UNIT CONTROL
LEVER WITH THE USE OF THE RADIO
MODULE AND BATTERY
TRANSMISSION MONITORING VIA THE LEDS
Different coloured leds are provided on the control lever as a visual aid for the user for
monitoring the transmission system�
The LEDs turn on at the same time for approx� 1 second when the TX unit switches on
for the self-test�
Note: to turn off the TX unit disconnect both the battery as well as the control cable�
When the control cable or the battery is reconnected the TX unit will switch on and
perform a self-test�
TX UNIT LED:
TX LED ON (GREEN)
"F" LED (RED)
STOP LED (RED)
LOW BATT LED (YELLOW)
FUNCTION OF THE TX LED ON:
When it is on this indicates that data is being transmitted from the transmitting unit to
the receiving unit following the activation of one or more commands�
It will remain on as long as the commands are activated�
FUNCTION OF THE "F" LED:
This LED turns on when the F key is pressed together with one of the keys that has a
second function�
In this way the operator has the confirmation that the command given to the machine is
the second function and not the main key function�
FUNCTION OF THE LOW BATT LED
This LED turns on when the TX unit power supply battery voltage is below the minimum
operating threshold�
When it turns on and stays on, this informs the user that the power supply battery must
be recharged�
Once the TX unit LED turns on, you can continue transmitting for limited time� After this
period of time, which depends on the type of use and general efficiency of the batteries,
the TX unit will turn off and remain inactive due to a lack of power�
The LOW BATT LED will turn off when the battery charger is connected to the TX unit�
FUNCTION OF THE STOP LED
The STOP LED turns on and remains on for the entire period that the stop key is pressed�
50
Operator's manual MONSTER AGTT
Publicité
Chapitres
Dépannage
