Installation; Installation Clearances; Working Environment Conditions; Fixing To The Ground - Corghi AGTT 1600A Manuel D'utilisation

WARNING
Take the utmost care when unpacking, assembling, lifting and setting up the machine
as indicated below.
Failure to observe these instructions can damage the machine and compromise the
operator's safety.
Remove the original packaging materials after positioning them as indicated on the
packaging and keep them for possible future shipping.
ATTENTION (for radio versions only)
Before starting with installation, make sure that no machines working with the same
frequency band are located within a radius of 200m from the selected installation
spot.
In the case of interference, request a different frequency band.
WARNING
Choose the place of installation in strict observance of local regulations regarding
safety in the workplace.
The floor must be able to support a load equal to the sum of the weight of the equip-
ment plus the maximum load allowed, taking into consideration also the resting base
and any fixing means envisaged.
Position the machine in a manner that guarantees access to all four sides. In particular,
check the minimum space required for the work indicated in Fig. 6:
- at the front for wheel loading and unloading;
- at the rear to be able to view the work being performed.
IMPORTANT: for correct, safe use of the equipment, we recommend a lighting level of
at least 300 lux in the place of use.
WARNING
If the machine is installed outdoors, it must be properly sheltered under a roof.
- Relative humidity: 30-95% without condensation
- Temperature range: 0° - +55°
WARNING
Use of the machine in a potentially explosive atmosphere is not permitted.
If the machine is to be fixed to the ground, use M16 expansion plugs in the areas indi-
cated in Fig. 7.
36

InSTAllATIon

Installation clearances

Working environment conditions

Fixing to the ground

Operator's manual AGTT 1600A - AGTT 1600