Adjusting The Wheel Locking Force; Adjusting The Cot Retaining Post - Stryker Power Pro Cot 6500 RUGGED Manuel D'utilisation

Adjusting The Wheel Locking Force

MINIMUM
1. To adjust the wheel locking force, remove the socket screw from the center of the lock pedal. The wheel lock is
initially assembled with the pedal set at the minimum locking force. The marker on the pedal (item A) is aligned with
the marker on the octagonal sleeve (item B).
2. Remove the sleeve (B). Rotate the sleeve counterclockwise to increase the pedal locking force and clockwise to
decrease the locking force. Insert the sleeve into the pedal. Reinstall the socket screw.
3. Test the pedal locking force and verify the pedal holds properly before returning the cot to service.

Adjusting the Cot Retaining Post

Retaining Post
Bottom Bracket
CAUTION
The ambulance cot fastener comes preconfigured for an X-Frame cot, if the fastener has been configured for an H-frame
style cot, the cot retaining post must be adjusted to accommodate the fastener.
1. Remove the bolts holding the two retaining post brackets to the base frame.
2. Turn the bottom bracket 180˚.
3. Reinstall the bolts.
NOTE
If the arrow on the bottom bracket of the retaining post points toward the head end of the cot, the retaining post is set for
an X-frame style cot. If the arrow points toward the foot end of the cot the post is set for an H-frame style cot.
0
Cot Features
Figure 26 - Wheel Locking Force Adjustment
Figure 27 - Cot Retaining Post
6500-009-005 REV A
Arrow
Bottom View
MAXIMUM
www.stryker.com