Battery Operation - Stryker Power Pro Cot 6500 RUGGED Manuel D'utilisation

Cot Operation

Battery Operation

Battery
Figure 64 - Battery Removal & Replacement
The ambulance cot is supplied with two removable 24-volt D WALT ® batteries as the power source. To install the battery,
e
align the tabs in the battery enclosure and push the battery into the enclousre until the latch clicks into place.
To remove the battery, locate the red battery release (A) along the patient left side of the foot end control enclosure. Push
the battery release button to release the latch. Slide the released battery out of the enclosure to the left (not shown).
To reinstall the battery, align the tabs in the battery enclosure and push the battery into the enclosure until the latch clicks
into place. The indicator will light GREEN, if the battery is fully charged or has adequate battery power. If the indicator
flashes red, the battery needs to be recharged or replaced.
NOTE
Keep your spare battery on the charger at all times. Batteries slowly lose power when not on the charger.
WARNING
To avoid risk of electric shock, never attempt to open the battery pack for any reason. If the battery pack case is cracked
or damaged, do not insert it into the charger. Return damaged battery packs to a service center for recycling.
Do not remove the battery when the ambulance cot is activated.
Avoid contact with a wet battery or battery enclosure. Contact may cause injury to the patient or operator.
CAUTION
Remove the battery if the cot is not going to be used for an extended period of time (over 24 hours).
www.stryker.com 6500-009-005 REV A 5