Stryker Power Pro Cot 6500 RUGGED Manuel D'utilisation page 57

In general, when used in those concentrations recommended by the manufacturer, either phenolic type or quaternary type
disinfectants can be used. Iodophor type disinfectants are not recommended for use because staining may result.
Suggested cleaners for the
Quaternary Cleaners (active ingredient - ammonium chloride)
Phenolic Cleaners (active ingredient - o-phenylphenol)
Chlorinated Bleach Solution (5.25% - less than 1 part bleach to 100 parts water)
Avoid over-saturation and ensure the product does not stay wet longer than the chemical manufacturer's guidelines for
proper disinfecting.
WARNING
SOME CLEANING PRODUCTS ARE CORROSIVE IN NATURE AND MAY CAUSE DAMAGE TO THE PRODUCT IF USED
IMPROPERLY. If the products described above are used to clean Stryker patient care equipment, measures must be
taken to insure the cots are wiped with clean water and thoroughly dried following cleaning. Failure to properly rinse and
dry the cots will leave a corrosive residue on the surface of the cots, possibly causing premature corrosion of critical
components.
NOTE
Failure to follow the above directions when using these types of cleaners may void this product's warranty.
REMOVAL OF IODINE COMPOUNDS
Use a solution of 1/2 tablespoons Sodium Thiosulfate in a pint of warm water to clean the stained area. Clean as soon as
possible after staining occurs. If stains are not immediately removed, allow solution to soak or stand on the surface. Rinse
surfaces which have been exposed to the solution in clear water before returning unit to service.
WARNING
Failure to properly clean or dispose of contaminated mattress or cot components will increase the risk of exposure to
bloodborne pathogens and may cause injury to the patient or the operator.
www.stryker.com
Cleaning
POWER PRO XT cot surfaces:
6500-009-005 REV A 55