Unloading The Cot From A Vehicle (Powered Method) - Stryker Power Pro Cot 6500 RUGGED Manuel D'utilisation

Unloading the Cot from a Vehicle - Powered Method
Unloading the cot from the vehicle while a patient is on the
cot requires a minimum of two (2) operators, positioned
at each end of the ambulance cot. Each operator must
grasp the ambulance cot frame securely.
Disengage the cot from the cot fastener (For more
detailed instructions, reference the ambulance cot
fastener installation/operation manual - Stryker part
number 6370-090-010).
Lift the vehicle bumper to the raised position (if
possible).
WARNING
Do not press the extend (+) button until the safety bar
engages the safety hook.
Operator 1 - Grasp the ambulance cot frame at the foot
end. Pull the cot out of the patient compartment until
the safety bar engages the safety hook. Operator
two should verify that the bar engages the safety
hook.
WARNING
To avoid injury, verify the safety bar has engaged the
safety hook before removing the ambulance cot from the
patient compartment.
Operator 2 - Stabilize the cot during the unloading
operation by securely grasping the outer rail.
Operator 1 - Depress the extend (+) button to lower the
undercarriage to its fully extended position (Figure
46).
Operator 2 - Push the safety bar release lever forward to
disengage the safety bar from the safety hook in the
patient compartment (Figure 47).
WARNING
Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury to
the patient or operator could occur.
Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
When unloading the cot from the patient compartment,
ensure the caster wheels are safely set on the ground or
damage to the product may occur.
Do not "jog" the cot past the load height while the safety
bar is engaged.
www.stryker.com
Cot Operation
Figure 45 - 2 Operators Unloading the Cot
Figure 46 - 2 Operators - One Pushing the Extend
Figure 47 - Disengaging the Safety Bar
6500-009-005 REV A
Button
5