Set-Up Procedures - Stryker Power Pro Cot 6500 RUGGED Manuel D'utilisation

The patient compartment of the vehicle in which the ambulance cot will be used must have:
• A smooth rear edge for cot loading.
• A level floor large enough for the folded cot.
• Stryker 6370/6374/6377/6378/6379 or 6371/6375 crash stable cot fastener (not included).
• In-fastener shut-off module installed and positioned properly.
• Space to install the safety hook.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
WARNING
Do not modify the
unit. Modifying the product can cause unpredictable operation resulting in injury to the patient or operator. Modifying the
product will also void its warranty.
Any emergency vehicle to be used with this ambulance cot must have the in-fastener shut-off system installed.
Refer to D WALT ® manual (Stryker part number 6500-700-006) for battery and charger operation.
e
NOTE
This manual should be considered a permanent part of the ambulance cot and should remain with the product even if the
cot is subsequently sold.
Stryker continually seeks advancements in product design and quality. Therefore, while this manual contains the most
current product information available at the time of printing, there may be minor discrepancies between your ambulance
cot and this manual. If you have any questions, please contact Stryker Customer Service or Technical Support at (800)
327-0770 or (269) 324-6500.
www.stryker.com
Set Up Procedures
POWER PRO XT ambulance cot or any components of the cot, including the hydraulic
6500-009-005 REV A 1