Wheel Locking Force Adjustment - Stryker Power-PRO TL Manuel D'utilisation Et D'entretien

English

WHEEL LOCKING FORCE ADJUSTMENT

Tools Required:
• 5/32" Allen Wrench
• 7/16" Combination Wrench or Socket
Procedure:
1. Using the 5/32" Allen wrench and 7/16" combination wrench or socket, remove the socket screw from the center of
the lock pedal. The wheel lock is initially assembled with the pedal set at the minimum locking force. The marker
on the pedal (A) is aligned with the marker on the octagonal sleeve (B).
2. Remove the sleeve (B). Rotate the sleeve counterclockwise to increase the pedal locking force and clockwise to
decrease the locking force. Insert the sleeve into the pedal.
3. Using the 5/32" Allen wrench and 7/16" combination wrench or socket, reinstall the socket screw.
4. Test the pedal locking force and verify that the pedal holds properly before returning the cot to service.
MINIMUM
Return To Table of Contents
1-74
Service Information
Figure 35: Wheel Locking Force Adjustment
6550-109-005 REV A
MAXIMUM
www.stryker.com