Publicité
2. Position the side of the bracket against either the left or right cabinet. If there is no
adjacent cabinet, align the edge of the bracket with the side panel of the range in its final
location. If the countertop overhangs the cabinet, offset the bracket from the cabinet by
the amount of overhang.
3. Mark the location for the pair of holes to be used (see illustration above).
NOTE: For FLOOR installation use either Loc A or B. For REAR WALL installation use
Loc C.
2: SECURE THE BRACKET
The bracket must be screwed to either the FLOOR or REAR WALL.
FLOOR Installation:
•
WOOD FLOOR: Use the screws provided to secure the bracket using the pair of marked
holes (either Loc A or B).
•
CONCRETE FLOOR: Using a concrete bit, drill a 5/32" pilot hole 2" deep into the
concrete at the center of each of the marked holes (either Loc A or B). Use the screws
provided to secure the bracket into the floor.
REAR WALL Installation: Use the 2 screws provided to secure the bracket using the pair of
marked holes at Loc C. The screws MUST enter into a wood sill plate. If the wall contains
any metal studs or similar materials, then the floor must be used.
Figure 10
3: CHECK THE BRACKET
After installing the bracket, slide the range into its final location. The rear leveling leg must
be fully inserted into the ANTI-TIP bracket as shown in Step 1. To check if the bracket is
installed and engaged properly, look underneath the range to see that the rear leveling leg
is engaged in the bracket. On some models, the storage drawer or kick panel can be
removed for easier inspection. If visual inspection is not possible, slide the range forward,
confirm the anti-tip bracket is securely attached to the floor or wall, and slide the range
back so the leveling leg is under the anti-tip bracket. If the range is pulled from the wall for
any reason, always repeat this procedure to verify the range is properly secured by the
anti-tip bracket.
NOTE: The anti-tip bracket must be PROPERLY INSTALLED and the rear leveling leg
must be FULLY ENGAGED into the bracket to prevent the range from tipping. NEVER
remove the leveling legs. This will prevent the range from being secured to the ANTI-TIP
bracket properly.
Figure 11
51
Publicité
