Publicité
Installation Instructions
IMPORTANT: This appliance shall be installed only by authorized persons and in
accordance with the manufacturer's installation instructions, local gas fitting regulations,
municipal building codes, electrical wiring regulations, local water supply regulations.
STEP 1 - UNPACK RANGE
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and film from the range. Keep cardboard bottom under
range. Do not dispose of anything until the installation is complete.
2. Remove oven racks and parts package from oven and shipping materials.
3. To remove cardboard bottom, first take four cardboard corners from the carton. Stack
one cardboard corner on top of another. Repeat with the other two corners. Place them
lengthwise on the floor behind the range to support the range when it is laid on its back.
4. Using two or more people, firmly grasp the range and gently lay it on its back on the
cardboard corners.
5. Remove cardboard bottom.
NOTES:
•
The leveling legs can be adjusted while the range is on its back.
•
To place range back up into a standing position, put a sheet of cardboard or hardboard
on the floor in front of range to protect the flooring. Using two or more people, stand
range back up onto the cardboard or hardboard.
STEP 2 - INSTALL ANTI-TIP BRACKET
NOTE: An anti-tip bracket kit is provided with the range.
WARNING: Tip Over Hazard
• A child or adult can tip the range and be killed.
• Connect anti-tip bracket to rear range foot.
• Reconnect the anti-tip bracket, if the range is moved.
• Failure to follow these instructions can result in death or serious burns to children and
adults.
IMPORTANT: DO NOT completely remove the rear leveling legs. The anti-tip bracket
uses either the right-hand or left hand, rear leveling leg to secure the range to the floor.
1: LOCATE THE BRACKET
Determine the final location of the range before attempting to install the bracket.
1. Place the bracket on the floor with the back edge against the rear wall. If the range does
not reach the rear wall, align the back edge of the bracket with the rear panel of the range
in its final location.
NOTE: If bracket does not touch the rear wall, you MUST screw bracket to FLOOR .
50
Publicité
