Publicité
POWER SUPPLY
IMPORTANT: To connect to an outlet in the wall, the electrical outlet must be recessed. If
the electrical outlet is in the floor, it can be either recessed or surface mounted.
ELECTRICAL REQUIREMENTS
IMPORTANT: This appliance is manufactured with the chassis connected to the neutral by
a green ground jumper wire. Use a 3-wire, UL listed, 50-amp power supply cord (pigtail); or
if local codes do not permit ground through the neutral, use a 4-wire power supply cord
rated at 250 volts, 50 amps and intended for use with ranges. The ground must be revised
so the green ground wire of the 4- wire power supply is connected to the chassis. See
"4-Wire Connection: "Power Supply Cord" and "Direct Wire - U.S.A. Only" "4-Wire
Connection (Ungrounded Neutral)" sections.
If codes permit and a separate ground wire is used, it is recommended that a qualified
electrical installer determine that the ground path is adequate and wire gauge is in
accordance with local codes.
To properly install your range, you must determine the type of electrical connection you
will be using and follow the instructions provided for it here.
•
Range must be connected to the proper electrical voltage and frequency as specified
on the model/serial number rating plate. All models are dual rated, and designed to be
connected to either 120/208 or 120/240V AC, 60Hz, 3- wire or 4-wire, single-phase
power supply.
Voltage and Frequency
240V, 60 Hz
208V, 60 Hz
•
When a 4-wire, single phase 120/240 volt, 60 Hz., AC only electrical supply is available,
a 50-amp maximum circuit protection is required (or, if specified on the model/serial
rating plate, when a 4-wire, single phase 120/208 volt 60 Hz., AC only electrical supply
is available, a 45-amp maximum circuit protection is required).
A 30" (76 cm)
B 171/2" (44 cm)
C 71/4" (18.4 cm)
D 3" (7.6 cm)
E Recommended Location for Electrical
Outlet
Amps
50 A
43 A
47
Circuit Required
50 Amp Circuit
45 Amp Circuit
Publicité
