Publicité
ENGLISH
WARNING: Before it is put into service, the system must be tested to check the operating
conditions of every single component and identify any malfunctions.
In this stage, it is important to check that all health and safety requirements have been complied
with in full.
To test the system, make the following checks.
1) Turn on the water supply taps and check that the connections are tight.
2) Turn on the master switch to check the electrical connection.
3) Make sure that the mains voltage is the same as that of the appliance and, if necessary, carry out the
conversion (see page 12).
4) Check that the safety device is operating correctly.
5) Carry out a cooking cycle without food to ensure that the appliance is operating correctly.
After testing, if necessary instruct the user in all the skills necessary for putting the appliance into opera-
tion in conditions of safety, in accordance with legal requirements.
The appliance's main functions do not require any special adjustments by specialist staff except the
settings made during use by the user.
14
TESTING OF THE APPLIANCE
ADJUSTMENTS
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
ADJUSTMENTS
3413811_inst_GB_rev.2
Publicité
