Publicité
ENGLISH
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identifi cation and correction of any anoma-
lies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specifi c technical knowledge or skill
is required, and so they must only be carried out by qualifi ed staff with recognised experience acquired
in the specifi c sector of operation.
NOTE: For all requirements contact the agents or the headquarters of Angelo Po which can
be found in the contacts section of the website http://www.angelopo.com.
Fault
The appliance does not switch on
Cooking cycle does not start or
stops suddenly
The cleaning cycle does not
start or stops suddenly
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to
identify the alarm signals which appear on the
display (A).
NOTE: Press RESET to reset the alarm and
the cooking cycle restarts automatically. Press
START if the cooking cycle does not restart auto-
matically.
48
FAULT
TROUBLESHOOTING
Cause
Fuse "blown"
Safety or protection device (safety
thermostat or overload cutout)
tripped.
Electronic circuit board damaged
Control board electronic circuit
board damaged
Alarm triggered
Control board electronic circuit
board damaged
Alarm triggered.
TABLE OF ALARM INDICATIONS
Remedy
Replace the fuse (see "installation
manual).
Press device reset button.
Contact the after-sales service.
Contact the after-sales service.
Consult the "Key to Alarms" table
Contact the after-sales service.
Consult the "Key to Alarms" table
A
FAULT
3413811_ut_GB_rev.2
Publicité
