Publicité
IGNITION SYSTEM
CDI MAGNETO INSPECTION
1. Inspect:
Pickup coil resistance
G
Out of specification → Replace.
Tester (+) lead → White/Red lead 1
Tester (–) lead → White/Blue lead 2
5PA60080
2. Inspect:
Charging coil 1 resistance
G
Out of specification → Replace.
Tester (+) lead → Black/Red lead 1
Tester (–) lead → Green/White lead 2
Charging coil 1
5PA60090
at 20 °C (68 °F)
3. Inspect:
Charging coil 2 resistance
G
Out of specification → Replace.
Tester (+) lead → Green/Blue lead 1
Tester (–) lead → Black lead 2
Charging coil 2
5PA60100
EC628000
CDI UNIT INSPECTION
Check all electrical components. If no fault is
found, replace the CDI unit. Then check the
electrical components again.
6 - 5
ELEC
Pickup coil
Tester selector
resistance
248 ~ 372 Ω at
20 °C (68 °F)
Tester selector
resistance
720 ~ 1,080 Ω
Tester selector
resistance
44 ~ 66 Ω at
20 °C (68 °F)
–
+
position
Ω × 100
position
Ω × 100
position
Ω × 10
Publicité
