Keysight Truevolt Serie Mode D'emploi page 154

Readings - Enter a Start Index (reading number) and Number of Readings to Get and click Get Data
l
to display those readings at the bottom of the window. Readings are not cleared from instrument
memory. Use the checkboxes to enable/disable the displayed Index or Units. Use the mouse to high-
light any displayed data and press Ctrl-C to copy to the Windows Clipboard. Click Clear Data Win-
dow to erase the readings in the display.
Last Value - Click Last Value > Get Data to display the last reading taken by the DMM.
l
Statistics Data - Click Statistics Data > Get Data to display Maximum, Average, Minimum, Max-Min,
l
Standard Deviation, and Samples (number of readings).
Histogram Data - Click Histogram Data > Get Data to display Reading Count, Auto Bin (On or OFF),
l
Number of Bins, Upper Range, Lower Range, and Bin Data.
For the Allow Full Control mode, this window has these additional controls:
Read and Remove Readings - The Start Index is fixed at 1. Enter the number of Readings to Remove
l
and click Get Data to display those readings at the bottom of the window. The readings displayed
ARE cleared from instrument memory.
Delete All Readings - Deletes all readings in the instrument reading memory and does not display
l
any readings.
DMM Overview
This window generates reports with information such as the instrument's firmware, configuration, cal-
ibration, SCPI configuration, and error queue. Check the desired boxes on the left side of the screen and
then click Generate Report. The Change in SCPI Configuration box produces a list of all of the SCPI
Keysight Truevolt Series Operating and Service Guide
Features and Functions
155