Publicité
Les langues disponibles
Les langues disponibles
Introduction to the Instrument
Default Gateway
A gateway is a network device that connects networks. The default gateway setting is the IP address of
such a device.
You need not set a gateway address if using DHCP.
l
Contact your LAN administrator for details.
l
This setting is non-volatile; it will not be changed by power cycling or
l
Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
l
Then set the first softkey to Manual and press More and Gateway. Then set the appropriate gateway
address using the arrow keys.
SCPI:
SYSTem:COMMunicate:LAN:GATeway "<address>"
l
If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
l
SYSTem:COMMunicate:LAN:UPDate
Hostname
A hostname is the host portion of the domain name, which is translated into an IP address.
The instrument receives a unique hostname at the factory, but you may change it. The hostname
l
must be unique on the LAN.
The name must start with letter; other characters can be an upper or lower case letters, numeric
l
digits, or dashes ("-").
This setting is non-volatile; it will not be changed by power cycling or
l
Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
l
Then press Host Name and enter the hostname with the front panel arrow keys.
SCPI:
SYSTem:COMMunicate:LAN:HOSTname "<name>"
l
If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
l
SYSTem:COMMunicate:LAN:UPDate
Domain Name
A domain name is a registered Internet name that gets translated into an IP address. You cannot set it
from the front panel or SCPI.
30
(remote interface) for the change to take effect.
(remote interface) for the change to take effect.
Keysight Truevolt Series Operating and Service Guide
*RST
or SYSTem:PRESet.
*RST
or SYSTem:PRESet.
Publicité
