Keysight Truevolt Serie Mode D'emploi page 394

SYSTem:BEEPer:STATe {ON|1|OFF|0}
SYSTem:BEEPer:STATe?
Disables or enables the beep heard during continuity, diode, or probe hold measurements, or when an
error is generated from the front panel or remote interface.
Parameter
{ON|1|OFF|0}. Default: ON. 0 (OFF) or 1 (ON)
Disable beeper state:
SYST:BEEP:STAT OFF
Does not affect the front panel key click.
l
A beep is always emitted (even with beeper state OFF) when
l
This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instru-
l
ment Preset (SYSTem:PRESet).
SYSTem:CLICk:STATe {ON|1|OFF|0}
SYSTem:CLICk:STATe?
Disables or enables the click heard when a front panel key or softkey is pressed.
Parameter
{ON|1|OFF|0}. Default: ON. 0 (OFF) or 1 (ON)
Disable keyboard click:
SYST:CLIC:STAT OFF
Does not affect the beeper for diode and continuity tests, errors and so on.
l
This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instru-
l
ment Preset (SYSTem:PRESet).
Keysight Truevolt Series Operating and Service Guide
Typical Return
Typical Return
SCPI Programming Reference
SYSTem:BEEPer is sent.
395