Water Connection; Water Treatment - Apach AP Serie Notice D'utilisation

E n g l i s h | 7
VI.

WATER CONNECTION

Make sure the device is placed near a water
connection.
Before connecting the device, allow enough
water through to remove any remnants in the
piping so that they did not get into the
magnetic valves.
It is necessary to install a shut-off valve and
mechanical filter between the plumbing and
the device.
On the back of the device, in the area marked
with a label, the convection oven has an input
G 3/4'' with a filter.
The inflowing water shall have a pressure
value comprised between 150 (1,5 bar) and
200 kPa (2bar) and a maximum temperature
of 30°C.
If the inflow pressure value exceeds 200kPa
(2bar), a pressure reducer will have to be
installed, calibrated at 200kPa (2 bar).
WASHING WATER CONNECTION
A shut-off valve and a mechanical filter must
be placed between the mains water supply
and the oven.
The rear of the oven has a G3/4'' inlet with
pipe.
ATTENTION: Before connecting the
appliance to the mains water supply, rinse
with water to eliminate any residue.
To guarantee proper operation of the cleaning
system, the mains water supply pressure
must be a minimum of 200 kPa (2bar) and the
temperature must not exceed 30°C.
Lower water pressure values may prevent the
cleaning system from working properly.

WATER TREATMENT

In order to ensure trouble-free operation of the device, the water should have a hardness of
maximum 5°f to prevent lime deposits.
For higher values a water softening station should be installed first.