Apach AP Serie Notice D'utilisation page 21

- CHIMNEY EXHAUST SELECTOR
Press the "exhaust button" and set "open status" or "close status".
When the "exhaust light" is ON the chimney is open, when the "exhaust light" is OFF, the
chimney is closed.
- STEAM REGULATION – for panel with encoder
Press the steam button and set the percentage of steam acting on the encoder knob +
press for confirmation. You can set from 0 – 10 and the below table will indicate the
percentage:
- STEAM REGULATION – for panel with buttons
Press the "steam" key and set the desired steam percentage using keys "+" and "-".
Press the "SET" button to confirm. It is possible to set 0 to 10, and the table below
shows the percentage values:
Value
0
1
2
3
4
5
- MANUAL HUMIDIFICATION
If you press the steam button this allows introducing steam as long as it remains pressed
- COOKING PROGRAMS STORAGE – for panel with encoder
1) Loading a storage cooking program: If you want to use memorized program press
the cooking program button and acting on the encoder you can select the program
number desired + press the encoder for confirmation and oven will start operating.
2) Load New program: If you want to memorize new program press the cooking program
button and acting on the encoder you must reach the first number that is flashing +
press confirmation.
Now you can start to inlet all information for the first phase (temperature, time, steam,
etc.) and you will see the light on the led n. 1 + press the cooking program button and
you will skip to second phase (see the led on n. 2 position). Introduce all information
for the second phase (temperature, time, steam, etc.) + press the cooking program
button and you will skip to third phase (see the led on n. 3 position). Introduce all
information for the third phase (temperature, time, steam, etc.) + press the cooking
program button and you will skip to fourth phase (see all 3 led lighting). Introduce all
information for the fourth phase (temperature, time, steam, etc.) + press the cooking
program button for 5 seconds until will appear MEM (means that program was
memorized).
In case the cooking process as only 1 or 2 phase when you finished to set the
information (temperature, time, steam, etc.) + press the cooking program button for 5
seconds until will appear MEM (means that program was memorized).
E n g l i s h
Steam Percentage
0%
10%
20%
30%
40%
50%
| 20
Value Steam Percentage
6
7
8
9
10 100%
60%
70%
80%
90%