Speed Regulation - Apach AP Serie Notice D'utilisation

- PRE-HEATING – for panel with encoder
This function is used to compensate the loss of heat that occurs upon opening the oven
and upon the introduction of food products there in. To activate pre-heating press the
cooking program button and acting on the encoder go to first program number that is
flashing + press for confirmation. Now we are on first phase so press the timer button and
acting on encoder go to "infin" (this means that the oven will run without specific timing) +
press encoder for confirmation. Now you can introduce the other phase as indicated
previously and at end memorize. The oven will start to pre-heat the cooking chamber until
reached 20% above the cooking temperature set and after you will hear beep sound. The
signal is interrupted by opening the door (to introduce the food products into the oven),
thus the stage preset by the program starts. The signal can be stopped without enabling
the stage or disabling preheating simply by pressing the START/STOP button.
- PRE-HEATING – for panel with buttons
This function is used to compensate for the heat loss that occurs after opening the
oven door and the introduction of food.
To activate the preheating of the oven, press the RECIPE BOOK key and, on the first
phase, (with LED no.1 on), use the "-" button until "INF" (infinite time) appears on the
display.
Press the "SET" key to confirm. You can now enter the other cooking phases. When
START/STOP is pressed, the oven will begin to preheat the cooking chamber until it
reaches a temperature 20% higher than the set temperature, which will beep.
The signal is interrupted by opening the door to introduce the food in the oven. When the
door is closed, the program pre-set phase will start.
The signal can be stopped without turning the preheating feature on and off by simply
pressing the START/STOP button.

SPEED REGULATION

-
The oven has two different speeds of the fan / motor:
1) Min: it means that the engine is at minimum speed and is used especially for delicate
dishes such as pastry
2) Max: means that the engine is at full speed and is used in most kinds of cooking.
To adjust the fan speed, press the speed button to enter the desired "Min" or "Max" that
you will see on the display
- START/STOP
This button starts/stops a previously set program or cooking program.
- ENCODER
The encoder knob rotates clockwise and anticlockwise; thus it increases or reduces the
figure indicated on display. Remember to press the encoder for confirmation also the
figure will continue to flash.
- CORE PROBE SECTION
Section where to introduce the core probe. The cooking time cannot be set given that
cooking will end upon reaching the set inner temperature controlled by the probe.
E n g l i s h | 22