Preparing For Installation; Electrical Connection - Apach AP Serie Notice D'utilisation

IV.

PREPARING FOR INSTALLATION

Remove the outer packaging (wooden caging and/or carton box) and dispose it in compliance
with the laws in force in the country of installation.
REMOVING PROTECTIVE FILM ETC
All packaging must be fully removed,
including the protective film applied on
external and internal
the
Remove all information covering from
the inside, and take off all plastic
packaging.
STAND ADJUSTMENT
Do not use the appliance without feet.
The adjustable feet are already screwed to the
underside of the oven.
If they are not used, this prevents airflow from cooling the electric parts and outsides of the oven
which causes over-heating and damage to components.
The oven will function correctly if placed level on a flat surface by adjusting the feet accordingly
and using a spirit level. Screw or unscrew them as necessary to adjust.
FITTING THE DRIP TRAY DRAIN
Fit the plastic clip and the white water
pipe that is inside the packaging. Check
that the pipe is firmly connected so that
water can flow from the tray to the drain
(see image).
V. ELECTRIC CONNECTION
WARNING: Main connections must be carried out by a qualified and authorized technician
according to national, international and local laws in the country where it is installed.
Before mains connection, ensure that the frequency (.....V) and voltage (....Hz) meet the
requirements indicated in the in the information tag on the back of the appliance.
The electric system, as prescribed and specified by the Standard in force, must be equipped with
an efficient ground.
It is possible to guarantee the electric safety of the appliance only in the presence of Standard
electric system.
For direct connection to the mains, it is necessary to interpose a device between the equipment
and the same mains, sized for the load, that ensure its disconnection.
The contacts must have an opening distance enabling the full disconnection, in conditions of
over-voltage category III, per compliance with installation regulations.
This device also must be located in a place and in a manner to be easily accessible at any
moment by the operator.
E n g l i s h
.
walls.
| 3