Apach AP Serie Notice D'utilisation page 20

- ON/OFF button
When power is supplied to the oven the control panel lights up and the operating display
indicates off. Activating the control panel requires pressing the on/off.
- TEMPERATURE SELECTOR – for panel with encoder
Press Temperature button, set the temperature value by acting on the encoder knob
rotates clockwise and anticlockwise, thus it increases or reduces the temperature which
appears on the temperature display and press the knob for confirmation. The oven will
show always the real temperature inside the cooking chamber. To see what temperature
was confirmed press the temperature button.
- TEMPERATURE SELECTOR – for panel with buttons
Press "temperature" key and use keys "+" and "-" to set the desired temperature value.
At the end of the programming stage, press the "SET" button to confirm.
During operation, the oven will display the value of the actual temperature inside the
cooking chamber.
To display the set temperature value, press the "temperature" key.
- CORE PROBE – for panel with encoder
For cooking with core probe you need to fit the under position, press the core probe
button and set the temperature value by acting on the encoder knob + press for
confirmation.
The oven turns off when the inserted core probe registers the food temperature
requested.
- CORE PROBE – for panel with buttons
To cook with the core probe, insert it into the lower part of the control panel.
Remove the cap, press the core probe button and set the temperature value with keys
"+" and "-". Press the "SET" button to confirm.
Cooking stops when the probe inserted into the food detects the requested food
temperature.
- DELTA T – for panel with encoder
For Delta T cooking, press the "Delta T" button and:
1) set the temperature value of core probe by acting on the encoder knob + press for
confirmation
2) set the Delta T temperature value (difference you want from core probe and cooking
chamber) by acting on the encoder knob + press for confirmation
Remember that you need to fit the core probe at the oven before starting this selection
- DELTA T – for panel with buttons
For Delta T cooking, press the "Delta T" button and:
1) Set the temperature value of the core probe by using keys "+" and "-". Press the
"SET" button to confirm.
2) Set the Delta T temperature value (temperature difference between the core probe
and cooking chamber) using keys "+" and "-". Press the "SET" button to confirm.
Insert the core probe in the designated oven slot before starting this operation.
Remember that you need to fit the core probe at the oven before starting this selection
E n g l i s h | 19
It
.