IV.
EXTRAORDINARY MAINTENANCE
It is advisable to have the appliance subjected to periodical checks (at least once per year) by a
specialized authorized technician.
Any maintenance, installation or repair work must be carried out by qualified authorized
personnel by contacting the Assistance Centre. Before carrying out any operation the appliance
must be plugged out at the mains, turn off the water mains taps and wait for it to cool down.
Before moving the appliance from position, check that the electricity and water connections
(electric cables water pipe and drainage) are correctly plugged out.
If the appliance is on wheels check that electric cables, pipes or anything else are not damaged
while moving it. Ensure the break is on. Avoid placing the device near heat (such as fryers etc.)
After carrying out the task and replacing the appliance in its initial position, check that the electric
and water are connected correctly.
V.
MAINTENANCE IN CASE OF BREAKAGE
If the appliance breaks, disconnect it from the mains and turn off water.
Before ringing Customer Service, check the chart below.
FAILURE
The oven doesn't
start
The fan stops while
the oven is on
Internal light does
not work
There is no water
inflow from the
humidifier pipes
Non-uniform cooking
The oven is
completely OFF
Water leaking from
the gaskets with the
door open
E n g l i s h
CAUSE
The door is not closed but open
Micro switch doesn't indicate
closed door
Safety thermostat measure motor
Motor capacitor break
Loose lamp
Blown lamp
Water inlet closed
Incorrect connection to the water
supply system
The water filters are blocked by
impurities at the top
The fans no long invert the
direction of rotation
One of the fans not operating
Failure of one of the resistances
Supply voltage failure
Incorrect connection to the power
supply network
Safety thermostat measure
Dirty lining
Damaged gasket
Problem regarding the closure of
the door
| 13
SOLUTION
Check that the door is closed
Contact specialized technician for repair
(Assistance Service ).
Turn off the oven and wait for the motor's thermal
protection to reset itself. If the problem persists, call
a specialized repair technician (Assistance Service).
Contact specialized technician for repair
(Assistance Service ).
Correctly fit the lamp into the lamp holder
Replace the lamp (see ordinary maintenance )
Open water inlet
Check connection to the water supply system
Clean the filters
Contact specialized technician for repair
(Assistance Service ).
Contact specialized technician for repair
(Assistance Service ).
Contact specialized technician for repair
(Assistance Service ).
Restore power supply voltage
Check connection to the power supply network
Contact specialized technician for repair
(Assistance Service ).
Clean the lining with a damp cloth
Contact specialized technician for repair
(Assistance Service ).
Contact specialized technician for repair
(Assistance Service ).