Removing And Replacing The Battery; Removing And Replacing A Smrt Pak - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

REMOVING AND REPlACING ThE BATTERy

The cot is supplied with two removable 24V SMRT Paks or 24V D
See the SMRT Power System Operations/Maintenance manual (6500-009-101) for additional SMRT Pak and SMRT
Charger information. See the

REMOVING AND REPlACING A SMRT PAK

WARNING
• To avoid risk of electric shock, never attempt to open the battery pack for any reason. If the battery pack case
is cracked or damaged, do not insert it into the charger. Return damaged battery packs to a service center for
recycling.
• Do not remove the battery when the cot is activated.
• Avoid direct contact with a wet battery or battery enclosure. Contact may cause injury to the patient or operator.
To remove the SMRT Pak:
1. Press the RED one hand release button (C) or press the battery release button (A) to release the SMRT Pak (B)
from the cot as shown in Figure 36.
2. Slide the released SMRT Pak out of the enclosure.
A
To reinstall or replace the SMRT Pak:
1. Align the tabs in the battery enclosure.
2. Push the SMRT Pak into the enclosure until the latch clicks into place.
• The cot power indicator LED is solid GREEN if the SMRT Pak is fully charged and ready.
• The cot power indicator LED flashes RED if the SMRT Pak needs to be recharged or replaced.
Note: Batteries slowly lose power when not on the charger.
CAUTION
Remove the battery if the cot is not going to be used for an extended period of time (more than 24 hours).
www.stryker.com
Operation Guide
Battery System manual for battery and charger information.
D WALT
®
e
Figure 36: SMRT Pak Removal and Replacement
6500-109-005 REV A
WALT ® batteries as the power source.
e
B
C
Return To Table of Contents
English
1-43