Publicité
FRONT BRAKE (TT-R125LW/TT-R125LWE)
REMOVAL POINTS
Brake fluid
1. Remove:
Brake master cylinder cap 1
G
NOTE:
Do not remove the diaphragm.
2. Connect the transparent hose 2 to the
bleed screw 1 and place a suitable con-
tainer under its end.
3. Loosen the bleed screw and drain the
brake fluid while pulling in the lever.
CAUTION:
Do not reuse the drained brake fluid.
G
Brake fluid may erode painted surfaces or
G
plastic parts. Always clean up spilled
fluid immediately.
Brake caliper
1. Remove:
Brake caliper 1
G
NOTE:
Turn the brake caliper counterclockwise and
pull out it from the guide pin 2 on the brake
caliper bracket.
Brake caliper piston
1. Remove:
Brake caliper piston
G
Use compressed air and proceed care-
fully.
WARNING
Cover piston with rag and use extreme
G
caution when expelling piston from cylin-
der.
Never attempt to pry out piston.
G
Brake caliper piston removal steps:
Insert a piece of rag into the brake caliper
G
to lock one brake caliper.
Carefully force the piston out of the brake
G
caliper cylinder with compressed air.
5 - 14
CHAS
Publicité
