Publicité
PRE-OPERATION INSPECTION AND MAINTENANCE
PRE-OPERATION INSPECTION AND MAINTENANCE
Before riding for break-in operation or practice, make sure the machine is in good operating condi-
tion.
Before using this machine, check the following points.
GENERAL INSPECTION AND MAINTENANCE
Item
Fuel
Engine oil
Gear shifter and clutch
Throttle grip/housing
Brakes
Drive chain
Wheels
Steering
Front forks and rear shock
absorber assembly
Cables (wires)
Muffler
Sprocket
Lubrication
Bolts and nuts
Lead connectors
Check that a fresh gasoline is filled in the fuel tank. Check the
fuel line for leakage.
Check that the oil level is correct. Check the crankcase for leak-
age.
Check that gears can be shifted correctly in order and that the
clutch operates smoothly.
Check that the throttle grip operation and free play are correctly
adjusted. Lubricate the throttle grip and housing, if necessary.
Check the play of front and rear brake and effect of front and
rear brake.
Check fluid level and leakage. (TT-R125LW/TT-R125LWE only)
Check chain slack and alignment. Check that the chain is lubri-
cated properly.
Check for excessive wear and tire pressure. Check for loose
spokes and have no excessive play.
Check that the handlebar can be turned smoothly and have no
excessive play.
Check that they operate smoothly and there is no oil leakage.
Check that the clutch and throttle cables move smoothly. Check
that they are not caught when the handlebars are turned or
when the front forks travel up and down.
Check that the muffler is tightly mounted and has no cracks.
Check that the driven sprocket tightening nut is not loose.
Check for smooth operation. Lubricate if necessary.
Check the chassis and engine for loose bolts and nuts.
Check that the CDI magneto, CDI unit, and ignition coil are con-
nected tightly.
Routine
3 - 3
INSP
ADJ
Page
P.1-12
P.3-7 ~ 10
P.3-4
P.3-4 ~ 5
P.3-15 ~ 20
P.3-21 ~ 22
P.3-27 ~ 28
P.3-28 ~ 32
P.3-23 ~ 26
—
P.4-2
P.3-20
P.3-33
—
P.1-5
Publicité
