Publicité
OIL PUMP
Oil strainer
1. Inspect:
Oil strainer
●
Cracks/damage → Replace.
Contamination → Clean the flushing oil.
ASSEMBLY AND INSTALLATION
Oil pump
1. Install:
Oil pump housing 1
●
Outer rotor 2
●
Inner rotor 3
●
Pin 4
●
Oil pump shaft 5
●
Pin 6
●
Oil pump cover 7
●
Washer 8
●
Circlip 9
●
Conical spring washer 0
●
Oil pump driven gear A
●
Circlip B
●
Screws C
●
NOTE:
Apply engine oil onto the outer rotor, inner
●
rotor and oil pump shaft.
Install the conical spring washer in the direc-
●
tion as shown.
2. Install:
Oil strainer
●
Gasket
●
Oil pump assembly
●
Screws (oil pump assembly)
●
NOTE:
Apply engine oil onto the crankcase oil pas-
sage and oil pump assembly.
3. Install:
Washer 1
●
Oil pump drive gear 2
●
Rotary filter 3
●
NOTE:
Install the washer with stamped "H" for the
●
side of the engine.
Install the oil pump drive gear with its groove
●
a facing the engine.
Install the rotary filter with the dog b facing
●
out.
Align the rotary filter dog b with groove c of
●
the crankshaft.
4 - 52
ENG
New
New
5 Nm (0.5 m · kg, 3.6 ft · lb)
New
7 Nm (0.7 m · kg, 5.1 ft · lb)
Publicité
