Corghi LaserLine EM 9580 Manuel D'utilisation page 82

MAINTENANCE
WARNING
the manufacturer is not to be held responsible for
any claims deriving from the use of non-original
spare parts or accessories.
WARNING
Unplug the machine from the power supply
and make sure that all moving parts have been
locked before performing any adjustment or
maintenance operation.
Do not remove or modify any part of the machine
(except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water
to remove dirt or residues from the machine.
Take all possible measures to prevent dust from
building up or raising during cleaning operations.
Keep the wheel balancer shaft, the securing
ring nut, the centring cones and flange clean.
These components can be cleaned using a brush
previously dripped in environmentally friendly
solvents.
Handle cones and flanges carefully so as to avoid
accidental dropping and subsequent damage that
would affect centring accuracy.
After use, store cones and flanges in a place where
they are suitably protected from dust and dirt.
If necessary, use ethyl alcohol to clean the dis-
play panel.
Perform the calibration procedure at least once
every six months.
INFORMATION REGARDING
MACHINE DEMOLITION
If the machine is to be scrapped, remove all
electrical, electronic, plastic and metal parts and
dispose of them separately in accordance with
current provisions as prescribed by law.
ENVIRONMENTAL
INFORMATION
The following disposal procedure shall be exclus-
82
ively applied to the machines having the crossed-
out bin symbol
This product
that can be hazardous to the environment and
to human health if it is not disposed of properly.
The following information is therefore provided
to prevent the release of these substances and
to improve the use of natural resources.
Electrical and electronic equipment must never be
disposed of in the usual municipal waste but must
be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product
and on this page, reminds the user that the product
must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non
specific treatment of the substances contained
in these products, or their improper use, or im-
proper use of their parts may be hazardous to the
environment or to human health. Furthermore, this
helps to recover, recycle and reuse many of the
materials contained in these products.
Electrical and electronic manufacturers and dis-
tributors set up proper collection and treatment
systems for these products for this purpose.
Contact your local distributor to obtain information
on the collection procedures at the end of the life
of your product.
When purchasing this product, your distributor will
also inform you of the possibility to return another
end-of-life piece of equipment free of charge as
long as it is of equivalent type and had the same
functions as the purchased product.
Any disposal of the product performed in a differ-
ent way from that described above will be liable
to the penalties provided for by the national
regulations in force in the country where the
product is disposed of.
Further measures for environmental protection
are recommended: recycling of the internal and
external packaging of the product and proper
disposal of used batteries (only if contained in
the product).
Your help is crucial in reducing the amount of
natural resources used for manufacturing elec-
trical and electronic equipment, minimise the
use of landfills for product disposal and improve
EM 9580 - Operator's manual
on their data plate.
may contain substances