Corghi LaserLine EM 9580 Manuel D'utilisation page 64

to indicate that the distance and diameter values have been acquired.
- Return the end of the automatic measuring arm in line with the plane selected for the application
of the outer weight (fig. 21), following the same procedure previously indicated for the inner side.
- Keep the arm in position and wait for the acoustic confirmation signal.
- Return the measuring arm to the rest position.
- Perform a spin.
- At the end of the spin, if you want to change the balancing programme set automatically by the
machine (FSP), select the balancing programme icon
button until the required programme is displayed.
Balancing weight application
- Select the plane where the first balancing weight is to be applied.
- Turn the wheel until the central element of the corresponding position indicator lights up.
If the weight to be applied is of the traditional clip type (inner side in ALU 2P), apply it to the 12
o'clock position. If instead the weight to apply is adhesive and the CLIP mode was selected (see the
" Selection of adhesive weight application position"):
- Centre it inside the cavity of the weight-holder terminal of the measuring arm (fig. 22 a,b), with the
backing paper of the adhesive strip facing up. Remove the protection (fig. 22 c) and turn the terminal
so that the adhesive faces the inner surface of the rim.
- Move the sensor until the two reference lines (green in colour) coincide in the relevant windows on
the screen.
- Turn the end of the measuring arm until the weight adhesive strip is in line with the rim surface.
- Press the button (fig. 22 d) to eject the weight and make it stick to the rim.
- Return the measuring arm to the rest position (fig. 22 e).
64
21
and press the Kis knob or the ENTER
EM 9580 - Operator's manual