Corghi LaserLine EM 9580 Manuel D'utilisation page 61

WINUT DEVICE
The machine can be fitted with the WINUT
device - i.e. the activation of the automatic
wheel locking device C via the button on the
sleeve C (Fig.18a) rather than via the control
pedal (L, Fig.10).
Fig.18a
This device can also be fitted on other machines,
by requesting the relevant accessory.
On the work screen, the machine visualises
certain icons relating to the device:
- : indicates that the machine recog-
nises the WINUT device;
- : indicates that the battery in the sleeve
C is charged;
- : indicates that the battery in the sleeve
C is at roughly the halfway point of its charge
level;
EM 9580 - Operator's manual
18
18a
- :indicates that the battery in the sleeve
C needs to be replaced;
To replace the battery in the sleeve C, proceed
as follows:
- Open the sleeve C by loosening the six M3
fixing screws (Fig.18b);
- Take out the battery holder (Fig.18c);
- Replace the battery in the sleeve C with a new
CR2450 3V (Fig.18d);
- Assemble the sleeve C, following the disas-
sembly instructions in reverse order.
18b
UK
18c
18d
61