Corghi LaserLine EM 9580 Manuel D'utilisation page 76

icon bar.
After the list of the configuration programmes is
displayed, proceed as follows:
- Select the preferred programmes icon
.
- All the utility and balancing programmes
icons are displayed.
- Select the two programmes to be displayed
in the main window by using the Kis knob or
ENTER button.
- Press the Exit button to save the setting and
exit .
Customisation Configuration
This programme allows the permanent storage
of some selected data, such as: name, surname,
city, street, telephone number, advertising
messages, etc.
The stored data are visualised on the initial
screen.
To access this programme you must:
• select the icon Utility programmes;
• select the icon Configuration programs;
• and select the icon Company data setting.
The screen which appears has:
• 4 lines for inserting the data;
• 3 lines for inserting the operator data;
• and 5 icons:
1. the Help icon,
2. the Logo icon,
3. the Capital/small letters icon,
4. the Operator data insertion icon,
5. and the Data insertion icon.
To insert the data, you must:
• Select the Operator data insertion or Data
insertion icon.
• Select the character with the Kis knob or the
arrow keys.
• Confirm by pressing the Kis knob or ENTER
button.
To save the settings and exit the program, select
the Exit button.
You are advised to set your own surname and
name on the first line, the city on the second line,
76
the street on the third line and the telephone
number on the fourth line.
Language configuration
The language of the messages displayed on the
monitor can be selected.
After the list of the setting programmes is dis-
played:
- Select the language setting
- A list of flags is displayed. Select the flag
corresponding to the desired language by
pressing the Kis knob or
- Press the Exit button to save the setting and
exit .
This programme can be exited only by select-
ing a language, then the unbalance image is
displayed again.
Lighting LED activation/
deactivation
It is possible to activate or deactivate the LED
light when present on the machine.
After the list of the setting programmes is dis-
played:
- Select the lighting LED activation/deactivation
icon
- Three icons will appear on the display that
represent the possible light modes, as shown
below:
LED1. In this configuration, the light turns on
when:
- at the end of a spin cycle if residual un-
balances are present for 30 seconds;
- in CP (centred position) for an additional
30 seconds.
LED2. In this configuration, the light turns on
in the conditions indicated for the LED1
programme and, in addition, also in the
following conditions:
EM 9580 - Operator's manual
icon.
the ENTER button .