Corghi LaserLine EM 9580 Manuel D'utilisation page 58

Returning the arm to the rest position makes it
possible for the operator to change this setting,
selecting and using the Kis knob or the enter
button to press the icon
the balancing programme switches from ALU 1P
to ALU 2P and vice versa.
Wheel data entry for wheel
balancers with an ultrasonic
sensor (if installed)
To enter the distance, diameter and width values
automatically, proceed as follows:
- Bring the automatic measuring arm into contact
with the inner side of the rim (fig.14). Take great
care to position the arm correctly so as to ensure
accurate data reading.
- Keep the arms in contact with the rim until the
machine has acquired the values. Geometric
58
ALU1P
. In this case,
data (distance, diameter and width) are dis-
played. The following screen appears during
this phase:
- if only one measurement is taken, the machine
interprets the presence of a rim with balan-
cing using a clip weight (Dynamic Balancing
Programme)
- when the automatic internal measurement arm
returns to the rest position, the following icons
are automatically displayed on the screen:
- : pressing the Kis knob or the
ENTER button enables alternatively the type of
tyre, that is P TYRE
for medium sized wheels (wheels with a tyre
shoulder that does not protrude much from the
rim) or LT TYRE
for large sized wheels (such as off-road, trucks
or wheels with a tyre shoulder that protrudes
considerably from the rim);
- : each time the Kis knob or the ENTER
key is pressed, the machine automatically
changes the type of balancing programme (vis-
ible in the chart on the screen) in the following
sequence: DYNAMIC-ALU1-ALU2-ALU3-ALU4-
ALU5-STATIC-MOTORCYCLE DYNAMIC-MO-
TORCYCLE ALU.
EM 9580 - Operator's manual
(Passenger Tyre)
(Light Truck Tyre)