Corghi LaserLine EM 9580 Manuel D'utilisation page 73

shaft locking device activates automatically.
Highest accuracy function
This function allows the operator to check the
balancing results on the screen with the best
possible accuracy ("Gr x1" or "Oz 1/10").
- Select the highest accuracy icon
- Keep thethe Kis knob or Enter
pressed as long as desired.
Spin Counter Function
To access this programme you must:
• Select the icon Utility programmes.
• Select the icon Configuration programmes.
• And select the icon Spin counters.
The screen which appears has 3 counters:
• The first shows the number of spins performed
during the entire working life of the machine.
• The second shows the number of spins per-
formed since the last machine reset.
• The third shows the number of spins performed
since the last sensitivity calibration.
To quit the programme, press the Exit
button.
Manual wheel data entry
function
If the automatic measuring arm fails to operate,
the geometric data can be entered manually
by following the procedure below:
- Select the manual wheel data entry icon
.
- The data screen showing the icons is dis-
played:
manual wheel data change;
EM 9580 - Operator's manual
unit-of-measurement (inch/mm)
change;
displays the help information regarding
.
the current screen.
button
- Select the dimension change icon
- The wheel balancer prepares for manual entry
of the width.
- Change the displayed value with the value
measured with the manual caliper using the
keypad.
- Press the the Kis knob or ENTER button to
confirm and switch to the diameter value
entry phase.
- Change the value of the diameter displayed
by entering that indicated on the tyre using
the keypad.
Press the the Kis knob or ENTER button to
-
confirm and switch to the distance value
entry phase.
- Using the keypad, modify the value measured
with the tape measure between the body and
the inner side of the rim.
- Press the Exit
the manual data setting.
After setting the dimensions manually, the re-
quired balancing programme can be selected
as follows:
- select the balancing programme icon
- press the Kis knob or the ENTER button.
Each time the Kis is pressed, the machine
automatically changes the type of balancing
programme (as shown on the graphic on the
video) in the following sequence:
Dynamic
.
button to terminate
UK
73