Corghi LaserLine EM 9580 Manuel D'utilisation page 65

a
b
d
- Repeat the operations to apply the second
balancing weight.
- Perform a test wheel spin to check the balancing
accuracy.
- If the weight to apply is adhesive and H12 mode
was selected, apply it on both the planes in the
position corresponding to 12 o'clock.
- If the weight to apply is adhesive and the
LASER mode was selected, apply the weight in
correspondence of the laser line in the position
in which the respective plane was acquired.
The rim surface must be perfectly clean to make
the weight stick efficiently to the rim. If neces-
sary, clean the surface using suitable cleansing
products.
NOTE: on the wheel balancers for the German
market, the weight must be applied as follows:
apply the weight manually by positioning it so
that its centre line is 15mm back from the contact
point of the measuring head with the rim.
EM 9580 - Operator's manual
(
c
This function is automatically enabled when an
ALU P program is selected.
It modifies the selected positions for the applic-
ation of adhesive weights, so as to ensure per-
fect balancing of the wheel using commercially
available adhesive weights (i.e. multiples of five
grams). The accuracy of the machine is thereby
improved, avoiding rounding off or cutting the
weights to be applied to come closer to the actual
unbalance values.
e
The modified positions, where the adhesive
weights are to be applied, are identified by the
22
user according to the information given by the
wheel balancer (see the BALANCING WEIGHT
APPLICATION section).
(
This programme divides the outer weight Pe into
two weights P1 and P2 located in any position
chosen by the operator.
The only condition is that the two weights and
the original outer weight Pe must be within an
angle of 120°, as shown in fig. 23.
Fig. 23. Conditions for using the Hidden Weights programme
The Hidden Weight programme is to be used on
alloy rims, only and exclusively in conjunction
with the ALU1P/ALU2P programme, when:
- when the outer weight would rather be hidden
behind two spokes for aesthetic reasons;
To use this programme, proceed as follows:
"Movable planes" program
ALU P
available with
"Hidden weight" programme
ALU P
available with
)
programmes only
)
programmes only
23
65
UK