Commissioning The Rc System - Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi

When the alignment is in parallel, the pinion on the clutch bell and the main pinion will run smoothly. If there is too
much tolerance this will destroy the toothed wheels in the long run, too little tolerance destroys the bearing in clutch
and engine.
Checking the tooth backlash
Insert a thin strip of paper both between the pinions on the
clutch bell and between the main pinions of the two-speed
transmission in the drive section.
• Turn gears by hand
• The paper strips must not rip apart when the wheels turn!
Readjusting the tooth backlash
• Loosen the four screws of the engine mounting on the
bottom of the chassis
• Align engine laterally and fasten screws again tightly
• Unscrew the four screws on the engine support and align
the engine vertically
h) Commissioning the RC system
Please note the separate operating instructions of your remote control system!
The operation of the transmitter is possible with rechargeable batteries and normal batteries. When using rechargeable
batteries, make sure that these have a high capacity. Otherwise, the service life is reduced. If you use batteries in the
remote control, we recommend the use of high-quality alkaline batteries. Ensure sufficient residual capacity with a
battery tester.
If the batteries/rechargeable batteries are empty, always replace the complete set (never individual cells!). Always use
batteries or rechargeable batteries of the same type and manufacturer. Never mix batteries with rechargeable batteries!
Powerful servos are installed in the model, which match the achievable speed and the vehicle weight. We thus advise
against using 4 batteries/rechargeable batteries (type AA) as receiver power supply.
NOTE!
To operate the receiver, you have to use a full-load 5-cell rechargeable battery pack (hump rechargeable
battery pack) with an operating voltage of 6V.
• Insert the 8 batteries/rechargeable batteries into the battery compartment of the transmitter and observe the correct
polarity!
• Open the RC box on the chassis.
• Connect the 6 V receiver battery (hump rechargeable battery pack) to the switch cable.
• Observe the correct polarity and a tight fit.
• Reinsert the hump battery pack with the cables and the plug into the RC box.
• Carefully connect both plugs.
• Carefully remove the receiver from the RC box and uncoil the antenna wire.
• Guide the antenna wire outwards through the opening in the cover of the RC box.
52