Plug-In Charger; Commissioning - Reely Dart 2.0 Notice D'emploi

b) Plug-in Charger
• The plug-in charger is only suitable for charging 6-cell NiMH rechargeable batteries.
Never use the plug-in charger for any other purpose. Never use the plug-in charger for charging LiPo
rechargeable batteries (or other rechargeable batteries than NiMH); there is a danger of fire and
explosion!
• Always observe correct polarity (plus/+ and minus/-) when connecting an NiMH rechargeable battery to
the plug-in charger.
• The plug-in charger is constructed pursuant to protection class II.
• Use only a proper mains socket of the public supply mains for voltage/current supply of the plug-in
charger.
• The socket to which the plug-in charger is connected must be easily accessible.
• Do not pull the plug-in charger from the mains socket at the cable. Always take it by the side of the
housing and pull it from the socket straight.
• Protect the plug-in charger from moisture and wetness as well as from damage.
If the plug-in charger has become moist or wet or damaged, do not touch it. Danger to life from electric
shock!
First deactivate all sides of the mains socket to which the plug-in charger is connected (e.g. switch off the
respective fuse or turn out the fuse. Then deactivate the FI protection switch).
Only then pull the plug-in charger from the mains socket; no longer use the plug-in charger, but dispose
of it environmentally compatibly.
c) Commissioning
• The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
• Only use a suitable drive battery for the vehicle. Never operate the speed controller with a mains adapter,
not even for test purposes.
• This vehicle is only suitable for a 6-cell NiMH drive battery (rated voltage 7.2 V) or a 2-cell LiPo drive
battery (rated voltage 7.4 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed
controller. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential).
Loss of guarantee/warranty!
• If a LiPo drive battery is used, the undervoltage protection of the drive battery must be switched on
before driving the vehicle. Otherwise, there may be deep discharge of the LiPo drive battery, which will
permanently destroy it.
• When putting the device into operation, always turn on the transmitter first. Only then must the vehicle's
drive battery be connected with the speed controller and the speed controller switched on. Otherwise,
the vehicle may show unpredictable responses!
37