Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi page 56

Function control of the throttle/brake servo
• Move the lever of the remote control (channel 2) towards the back (full throttle position). The slide carburettor must
now be completely pulled out, the carburettor outlet opened to its maximum. The brakes have no impact.
• If the slide carburettor does not open when you operate the remote control, set the servo reverse for channel 2 to
"REV" to reverse the rotation direction of the servo.
• If the slide carburettor only opens partly, correct the servo travel at the trim (channel 2) of the remote control transmitter.
• Release the lever of the remote control.
Now the slide carburettor must go back to the idle speed position (carburettor outlet opened to approx. 1 mm).
The brake has no function still .
• Press the lever of the remote control forward as far as it will go (braking).
The slide carburettor must remain in the idle speed position (carburettor outlet opened to approx. 1 mm).
The servo lever at the carburettor linkage pulls against a spring resistance, the servo lever at the brake linkage
operates the brake levers.
• Release the lever of the remote control again; now the brakes should release again.
• You can adjust the brake linkage by moving the adjustment rings at the brake link lever accordingly.
56