Starting The Engine - Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi

In order to reset the factory setting proceed as follows:
• Open the slide carburettor completely
• Keep the slide open and turn the idle speed mix adjusting screw clockwise until it stops.
• Now unscrew turning it by 7.5 rotations anticlockwise.
m) Starting the engine
General information about combustion engines
When putting the new engine into operation, you have to observe a certain run-in time. During the run-in
time, engine parts tune to one another, whereby maximal capacity is reached and premature wear is prevented.
Thus, the run-in procedure must be carried out with the highest accuracy!
Preparations
• The carburettor is already roughly preadjusted.
• Before running the engine blow compressed air into the latter.
This way you make sure that the combustion chamber is free of dirt which could get into the engine via the
spark plug seat.
• Insert a glow plug with the thermal value medium to extra cold (depending on the fuel).
• Oil the air filter slightly in order to filter out dust particles
• Insert the glow plug.
• Open the tank lid and fill in the fuel.
Start the motor
The wheels must be freely suspended in the air! Place the model e.g. on a suitable car stand.
• Pull the cable starter several times (slowly!) to suck fuel into the carburettor.
• Do this until there are no more visible air bubbles in the fuel hose and the fuel just about reaches the carburettor.
Attention!
Don't pull out the cable starter all the way but only to a maximum of 3/4 of its length. Determine the length of
the pull starter by pulling it out slowly without ignition!
Never pull out the cable starter by force!
58