Tools And Aids; Check List For Commissioning; Check Alignment And Tooth Backlash Of Drive - Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi

e) Tools and aids
The model is readily mounted (RtR = Ready to Run). Prior to the start, you have to make and check a few basic
settings as well as provide the necessary accessories and operating materials.
Go through the various points of the check list one after the other, and your model is then ready to run.
Tools:
• Socket wrench for the wheel nuts
• Flat spanner 5mm and 5.5 mm to set alignment and inclination
• Allen key 1.5 mm for the grub screws on the adjusting rings of the throttle/brake and steering linkages
• Phillips screwdriver
• Normal screwdriver for the throttle stop screw and the main nozzle needle
Auxiliary materials:
• Cable fastener
• Air filter oil
• After-run oil (special low-viscosity machine oil for lubrication and protection of the combustion chamber from corrosive
residues in the engine after operation)
f) Check list for commissioning
What must be done:
• Checking all screw connections and wheel nuts

• Check alignment and tooth backlash of drive

• Function control of servos
• Checking the range of the remote control transmitter
• Check basic carburettor setting
• Screw in glow plug
• Fill in model fuel
• Let engine run
Attention! Position indications (front/rear/right/left) always refer to the longitudinal vehicle axis in driving
direction (seen forward)!
g) Check alignment and tooth backlash of the drive
The engine transmits its power via the pinion on the clutch bell to the two main pinions of the two-gear drive, which are
connected with a one-way bearing. Both rotary axes, i.e. the crank shaft, engine side, and the axis of the drive section
to the front and rear axis, must be aligned exactly parallel to each other. This prevents tensions in the drive section,
premature wear of the pinions and bearing journals as well as loss of power.
The parallel alignment of crankshaft and drive section has to be checked every time before using the vehicle
and if necessary it has to be readjusted!
51