b) Commissioning
The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
• Only use suitable drive batteries for the vehicle (see „Technical Data"). In the case of operation with unsuitable drive
batteries, there is a danger of damaging the vehicle (speed controller, receiver, servos, motor). Never operate the
speed controller with a mains adapter, not even for test purposes.
• Always commission the vehicle according to the following sequence. Otherwise, unpredictable reactions of the
vehicle may result! Also observe chapter 8.
F
B
Step 1:
Place the vehicle on an appropriate surface so that the wheels can turn freely.
Step 2:
Check the position of the on/off switch (A) of the speed controller and place it in the „OFF" position (switched off).
Step 3:
Switch on the transmitter if you haven't done so already. Check its function (e.g. operation display of the transmitter).
Step 4:
Put the of/off switch (B) for receiver power supply to the „OFF" position.
38
E
D
A
C