Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi page 77

Engine gets too hot
Motor rotation speed does not
decrease
Chassis
Model pulls to one side
Model can be controlled but only
with difficulty
Brake does not engage
Clutch does not engage
Clutch does not separate
Model does not run
Damping not soft and accessible
Shock absorbers loose oil
Model rolls over backward when
accelerating
Mix is too lean
Body too tight
Wrong fuel
Throttle stop screw is misadjusted
Engine takes in dead air
One or several sealing rings on the carburettor are defect
Steering trim wrongly set
Different cam on the left and right
Wheel broken on one side or bearing defect
Servo linkage is not adjusted correctly
Insufficient antenna reception
Batteries of transmitter and/or receiver are discharged
Brake steerage misadjusted
Brake disks worn out
Clutch cheeks worn out or broken
Clutch bell worn out or broken
Loose flywheel
Springs for clutch cheeks worn or broken
Main gearwheel defect
Defect gearwheels in the differentials
Centrifugal clutch set too loosely
One or several shock absorbers stuck
Piston rod bent
Dampening component(s) defect
Seals are worn out
Centrifugal clutch set too tight
Set the main nozzle needle to a fatter mix
Ensure sufficient air intake/extraction to the engine by cutting
out the body accordingly
Use RC car fuel only
Reset throttle stop screw to factory settings
Check and tighten all engine screws
Replace the defective joint rings
Correct the neutral position on the remote control
Reset the cam to 0° on both sides
Take the wheel off, clean the bearing and exchange it if
necessary
Place the servos in neutral position and readjust
Fully extend the transmitter antenna, completely uncoil
the receiver antenna and guide upwards
Replace batteries or recharge rechargeable batteries
Correct the setting of the brake steerage lever
Replace the brake disks
Replace the clutch cheeks
Replace the clutch bell
Tighten the flywheel attachment
Replace springs
Replace the main gearwheel
Replace the gearwheels
Adjust the centrifugal clutch
Clean and/or dismantle the shock absorber
Repair the piston rod
Check and replace the respective part
Replace the seals
Loosen the adjuster screw until the model starts softly
77