Reely 1:8 GP Buggy Ultra Sonic 4WD RtR Notice D'emploi page 59

• Attach a glow plug starter with completely charged starter battery on the glow plug (see ill. on
the right). Ensure a tight fit!
• Now pull the cable pull starter through until the motor starts up. Hold the model firmly with one
hand.
However, never reach into the drive because this could cause the engagement of the
sliding clutch. Risk of injury!
• Once the motor is running, let go of the cable starter and remove the glow plug starter.
Only leave the glow plug starter connected to the engine briefly. Otherwise, the glow
plug may burn out prematurely.
• If the pull starter can only be actuated with a lot of force after several unsuccessful start attempts,
too much fuel got into the combustion chamber and the crankcase. The engine was flooded.
Refrain from further start trials and remove the excess fuel in order to prevent damaging
the cable pull starter and the engine!
For this purpose, proceed as follows:
• Carefully turn in the main nozzle needle clockwise, as far as it will go.
• Unscrew the glow plug and check its glow function
• Place a piece of cloth on the engine and pull the cable pull starter 5-6 times (3/4 of the length!): Fuel is pumped out
and evaporates.
• Now insert the glow plug again.
• Unscrew the main nozzle needle with 3 rotations anticlockwise.
• Repeat the start process.
If the engine does not start after at most 10 attempts, proceed as described above or try to locate the error in the
troubleshooting table!
Switching off the engine
Cut off the air supply to the carburettor. For this purpose, proceed as follows:
• Cover the exhaust with a motor stopper (alternatively a rag) or stop the flywheel of the engine on the bottom of the
chassis while wearing gloves.
The fuel supply should not be disconnected as otherwise the engine could overheat.
59