Wacker Neuson RT82-SC3 Notice D'emploi page 83

RT / RTx
5.11 Calibrating the Joysticks
To determine if calibration is needed, press and release the red ON/OFF
pushbutton (j).
■ If the joysticks are out of calibration, the signal transmission indicator (n) will
illuminate red and remain lit, and the operating status indicator (f) will blink.
■ If the joysticks are calibrated, the signal transmission indicator will remain dark,
and the operating status indicator will blink.
Calibration All four joystick positions must be calibrated before the transmitter can return to its
procedure
normal operating mode. Perform the procedure below to calibrate the joysticks.
1. Press and release the ON/OFF pushbutton to power up the transmitter.
2. Press and hold the ON/OFF pushbutton for approximately 3 seconds until the
operating status indicator illuminates and remains lit. Release the ON/OFF
pushbutton.
3. Press and hold the ON/OFF pushbutton again for approximately 3 seconds until
the operating status indicator flashes rapidly. Release the ON/OFF pushbutton.
4. Move the forward/reverse joystick (c) all the way forward and hold it in place.
While holding the joystick, press and release the ON/OFF pushbutton—the
signal transmission indicator will flash. Release the forward/reverse joystick.
5. Move the forward/reverse joystick all the way backward and hold it in place.
While holding the joystick, press and release the ON/OFF pushbutton—the
signal transmission indicator will flash. Release the forward/reverse joystick.
This procedure continues on the next page.
wc_tx003818gb_FM10.fm
Engine Control Module (ECM) Diagnostics
n
f
83
g
j
c
wc_gr010840