Publicité
Les langues disponibles
Les langues disponibles
RT / RTx
Continued from the previous page.
3. Turn on the SmartControl™ SC-3 transmitter by pressing the red ON/OFF
pushbutton (g). Make sure the amber indicator lights in the light rings (c) are
flashing at a slow rate. This indicates infrared reception and that the transmitter
is at the correct distance from the machine. If they are not flashing, it indicates
that either the transmitter is not on or that the control channel of the transmitter
does not match the control channel of the machine. If they are flashing at a fast
rate (three times per second), it indicates that the transmitter (and operator) are
too close to the machine. Reposition the SmartControl™ SC-3 transmitter so
that the indicator lights flash at a slow and steady rate. If you are operating
multiple rollers, check to make certain each roller and its accompanying
transmitter are set to a different control channel.
4. After approximately 2 seconds, if engine conditions dictate (coolant temperature
too cool), the glow plug indicator (h) will illuminate and the light ring will flash
red, signifying that the glow plugs are on. The colder the engine coolant
temperature, the longer the glow plugs will stay on:
■ approximately 30 seconds at 0°C (32°F) for Kohler powered machines.
■ approximately 5 seconds at 0°C (32°F) for Kubota powered machines.
Note: The starter will not crank during the glow plug cycle.
5. Immediately after the glow plug light (h) and red light ring (c) go out, press the
engine start pushbutton (j) and hold it down until the engine starts. If the
machine fails to start within 15 seconds of cranking, release the engine start
pushbutton. Press the red ON/OFF pushbutton to turn the transmitter off. Wait
30 seconds, then turn the transmitter back on and repeat the starting procedure.
6. Once started and sufficient oil pressure is sensed, the oil pressure indicator will
go out.
7. Allow the unit to warm up a minimum of 5 minutes before engaging the throttle
switch (a) to the high (fast) position.
WARNING
Personal injury or equipment damage hazards. The roller's sensing system will not
stop the roller from moving when the transmitter is in the storage compartment or
on the side of the roller.
► When operating from the side of the machine, always maintain a distance of at
least 2m (6.6 ft.) from the machine.
► Never operate the machine with the transmitter in the storage compartment.
WARNING
Personal injury hazard.
► Stop the machine if people enter in the work area of the machine.
This procedure continues on the next page.
wc_tx003863gb_FM10.fm
65
Operation
Publicité
