Publicité
Les langues disponibles
Les langues disponibles
Know the Rules
Most job sites have rules governing equipment use and
maintenance. Before you start work at a new location,
check with the supervisor or safety coordinator. Ask
about the rules you will be expected to obey.
OSHA enforces federal laws within the United States
that apply to the safe operation, application and
maintenance of equipment on some jobsites. It is the
employer's responsibility to comply with these laws. A
federal representative may periodically inspect a jobsite
to see that these laws are being followed.
There may be other local, state/provincial, federal laws
or international organizations that regulate the use of
this equipment, along with specifi c jobsite or employer
rules. It is important that you know and comply with all
applicable laws and rules, including those requiring
operator training and certifi cation.
These are some of the rules you must work by:
• Only qualifi ed and authorized individuals may operate
this equipment.
• Inspect your machine and attachments before each
use as specifi ed by the manufacturer and your
employer.
• Never allow children to play near, ride on, or
operate the equipment.
• Keep bystanders well clear of the operation.
• Know the work area before you use the equipment.
Be aware of possible hazards, including those
overhead and underground.
• Only use attachments and parts that are approved by
the manufacturer.
• Do not allow riders.
• Fasten seat belt or operator restraint before starting.
• Drive forward whenever possible.
• Always look in the direction of travel.
• Check correct mirror settings, if available.
• Look before backing up.
• Never leave the operator's seat without stopping the
engine and removing the ignition key, if equipped.
(See page 30, Safe Shutdown.)
• Use three-point contact (handholds and steps) and
face the equipment when mounting or dismounting.
(See page 17, Mount and Dismount Properly.)
10
Follow a Safety Program
Follow a Safety Program
• Know the capacity and operating characteristics of
your equipment. Do not misuse it.
• Wear proper clothing and PPE. Check that others are
also wearing appropriate clothing.
• All shields, guards, air fi lters, access panels and
doors must be properly installed before each use.
• Know the rules regarding traffi c at your jobsite. Know
what all signs, fl ags, and markings mean. Know hand,
fl ag, horn, whistle, siren, or bell signals, if used.
• Never modify or remove any part of the machine
(except for service; then make sure the part is re-
installed or replaced if defective or worn out).
Safety Rules
•
•
•
•
•
•
•
•
•
•
Know and understand
rules of operation
Understand
jobsite
signals
Fasten seat belt
or operator restraint
Keep bystanders
away
9
Publicité
