Wacker Neuson RT82-SC3 Notice D'emploi page 47

RT / RTx
Ref. Component
e Engine oil pressure light
f Coolant temperature light
g Coolant level light
h Stability light
j Keyswitch
wc_tx003863gb_FM10.fm
Description
The oil pressure warning light illuminates when oil
pressure falls below the engine manufacturer's
recommended value. During such a condition, the
engine will automatically shut down.
The cooling temperature warning light illuminates
when engine coolant temperature exceeds 230°F
(110°C). During such a condition, the engine will
automatically shut down.
Allow temperature to drop below 212°F/100°C
before attempting to restart.
The cooling level warning light illuminates when
coolant level is too low. During such a condition, the
engine will automatically shut down.
The stability warning light illuminates when the pitch
of the roller exceeds 45°. The machine is equipped
with safety switches that shut down the engine
during such a condition.
Turning the keyswitch to the ON (I) position supplies
12VDC power to the machine. The green power-on
indicator (k) illuminates indicating power is on.
The keyswitch has an automatic shutoff feature that
powers off the electronics after one hour of non-
engine run time. To reset the machine, turn the
keyswitch to the OFF (O) position and then back to
the ON (I) position.
The machine can be restarted within this 1-hour
period if the transmitter is turned off and then on. The
glow plugs will be activated if needed.
All shutdown functions have a fault detection feature
where the warning light and red LED light rings
remain on after the machine shuts down, until the
fault is corrected, and the keyswitch is turned to the
OFF (O) position.
All shutdown functions and the air filter restriction
circuit have built-in circuitry to detect a possible bad
sensor, unplugged sensor, or a cut or damaged wire
to the sensor. Whenever any of these sensor faults
occur, the corresponding control panel light will flash
on and off.
47
Operation