Publicité
Les langues disponibles
Les langues disponibles
Keep wheel lug nuts tightened to manufacturer's
recommendations.
An increase in tire pressure during operation is normal,
and should NOT be reduced.
Never reinfl ate a tire that has been run fl at or seriously
under-infl ated without removing the tire from the wheel.
Have the tire and wheel closely inspected for damage
before remounting.
When adding air to a tire, do so from a distance. Always
use a long hose with a self-attaching chuck; stand away
from the tire sidewall and to one side as far as possible.
Do not infl ate tires with fl ammable gases or from
systems using an alcohol injector.
Roll-Over Protective Structure
(ROPS) and Falling Object Protective
Structure (FOPS) Safety Precautions
Do not remove the ROPS/FOPS except for service. Reinstall
them correctly before allowing the machine back into service.
Do not modify ROPS/FOPS in any manner.
Unauthorized modifi cations such as welding, drilling,
cutting or adding attachments could weaken the
structure and reduce your protection. Replace ROPS/
FOPS if subjected to rollover or damage. Do NOT
attempt to repair them. See the manufacturer's
manual(s) for complete instructions and inspection
requirements.
If your machine is equipped with a foldable ROPS, make
sure it is upright whenever the machine is in use.
Complete Service and Repairs Before
Machine is Released
Tighten all bolts, fi ttings, and connections to torques
specifi ed by the manufacturer.
Are there any missing cotter pins, washers, locknuts,
etc.? Are there any parts left over?
42
Perform Maintenance Safely
Avoid tire
explosion
Perform Maintenance Safely
Perform Maintenance Safely
Never cut or weld on a wheel with an infl ated
tire mounted on it. This could cause explosive
decompression.
Check that the tire size and wheel are correctly matched.
When replacing the tires, ensure the tires are of the
appropriate rating specifi ed by the manufacturer.
WARNING! Avoid death or serious injury. Always
use a safety cage or cable restraints when reinfl ating
a repaired tire.
Tires should not be operated at speeds higher than their
rated speed.
Start the engine and check for leaks. (See page 36,
Hydraulic System Hazards.) Operate all controls to
make sure the machine is functioning properly. Test
the machine if necessary. After testing, shut down and
check the work you performed.
Recheck all fl uid levels before releasing the equipment
for operation.
All parts should be inspected during repair and replaced
if worn, cracked or damaged. Excessively worn or
damaged parts could fail and cause injury or death.
Install all guards, covers, and shields after servicing.
Refi ll and recharge pressure systems only with
manufacturer-approved or recommended fl uids.
Use safety
devices when
reinfl ating
tires
Verify service work
when completed
41
41
Publicité
