Publicité
Les langues disponibles
Les langues disponibles
Check the Machine
Before beginning your work day, inspect the machine
and have all systems in good operational condition.
• Perform daily and periodic service procedures as
instructed by the equipment manufacturer.
• Check for broken, missing, loose, or damaged parts.
Make necessary repairs.
• Check that all drum mounting bushes are pliable and
free from damage.
• Check the water sprinkler system. Open the valve
and make sure water fl ows through every hole in
each spray bar.
• Check the tires for cuts, missing lugs, bulges, and
correct pressure.
• Keep the steps and handholds clean and free of
grease, oil, dirt, snow or ice.
• Check the parking brake for proper operation.
• Check condition and operation of any attachments.
• Ensure shielding is properly installed and in good
condition. Repair or replace if damaged or missing.
• Ensure work lights (if equipped) are kept clean. Check
that all lights work properly.
• Ensure the horn and back-up alarm (if equipped) are
operating correctly. Repair or replace if damaged.
If a leak is discovered:
• Ensure engine is turned off; relieve pressure in
hydraulic circuit.
• Wear proper hand and eye protection.
• Visually examine the hydraulic hose or fl uid lines in
the vicinity of the leak for breaks or cracks. Do not
use your hand to check for leaks.
• Repair or replace hydraulic lines per manufacturer's
recommendation.
Fluid injection injuries are not always obvious. Victims
have reported such injuries feel like a bee sting or
splinter under the skin. If you suspect you have a fl uid
injection injury, do not take chances. Seek proper
medical care immediately. If any fl uid is injected into the
skin, it must be surgically removed within a few hours by
a doctor familiar with this type of injury.
Check the Cooling System
When checking the cooling system, make sure the
engine is turned off and is cool. Remove the key to
prevent fans from unexpectedly starting. Ensure the
coolers and engine compartment are clean and free
from debris, which could ignite and cause a fi re.
14
Prepare for Safe Operation
Prepare for Safe Operation
• Ensure any Slow Moving Vehicle (SMV) signs,
refl ectors and warning lights are in good condition and
can be clearly seen. Repair or replace if damaged.
• Ensure all tools or loose objects are removed or
securely fastened while operating the machine.
• Check for damaged or leaky hydraulic systems.
Repair or adjust as needed.
Hydraulic Fluid Injection Hazard
WARNING! Accidental injection of high-pressure oil
into the hands or body is dangerous and could result in
death or serious injury. Use caution when checking
hydraulic leaks as pressurized hydraulic fl uid has
enough force to penetrate skin, causing serious
personal injury.
If the machine is air-cooled, be sure the cooling unit
has an unobstructed air fl ow. If it is liquid-cooled, check
coolant level (at overfl ow tank, if provided).
WARNING! Allow the radiator to cool before
checking the level. Hot radiator fl uids could escape as
steam and burn you. (See page 36, Engine Coolant
Hazards.)
Inspect
the machine before
each work shift
Wear
eye protection
High pressure
fl uid can inject
into the body
13
Publicité
