Wacker Neuson RT82-SC3 Notice D'emploi page 81

RT / RTx
Code Description
E00
E01
E02
E03
E04
E05
E06
E07
E08
E09
E10
E11
E12
E13
E14
E15
E16
E17
E18
E19
E20
E21
E22
E23
E24
E25
E26
E27
E28
E29
E30
E31
E32
E33
E34
E35
wc_tx003818gb_FM10.fm
Engine Control Module (ECM) Diagnostics
Possible bad glow time sensor
Possible bad temperature sensor
Possible bad air flow sensor
Possible bad oil pressure sensor
Possible bad tip sensor
Temperature sensor was unplugged
Air restriction sensor was unplugged
Oil pressure sensor was unplugged
Open starter solenoid
Open fuel solenoid (Kohler powered machines only)
Open stop solenoid (Kubota powered machines only)
Open throttle hold solenoid
Open throttle pull relay
Open glow plug relay
Open RX power relay
Open LED ring output
Low battery
Starter solenoid
Shorted fuel solenoid (Kohler powered machines only)
Shorted stop solenoid (Kubota powered machines only)
Shorted throttle hold solenoid
Shorted throttle pull relay
Shorted glow plug relay coil
Shorted RX power relay coil
Shorted LED ring output
High oil pressure on power up
Starter solenoid over current
Fuel solenoid over current (Kohler powered machines only)
Over-current stop solenoid (Kubota powered machines only)
Throttle hold solenoid over current
Throttle pull relay coil over current
Glow plug relay coil over current
RX power relay coil over current
LED ring output over current
Open
High starter solenoid current
High fuel solenoid current (Kohler powered machines only)
High stop solenoid current (Kubota powered machines only)
High throttle hold solenoid current
High throttle pull relay coil current
81