Wacker Neuson RT82-SC3 Notice D'emploi page 114

Troubleshooting
Problem Reason
No vibration Machine in high speed travel mode
Faulty vibration switch or poor
connection inside transmitter
Inoperative solenoid on vibration valve Repair or replace.
Damaged exciter assembly
Damaged exciter motor coupling
Damaged exciter motor
Damaged exciter pump
Machine out of infra-red signal range
Operator too close to machine
Communication fault
No travel, or Faulty forward/reverse switch or poor
travel only in connection inside transmitter
one direction
Inoperative solenoid on travel valve
Damaged drive gearcase assembly
Loose, broken or corroded wire
connections inside control panel or
transmitter
Damaged drive motor
Damaged drive pump
Machine out of infra-red signal range
Operator too close to machine
Communication fault
No high Faulty forward/reverse switch or poor
speed travel connection inside transmitter
Inoperative solenoid on manifold
Loose, broken or corroded wire
connections inside control panel or
transmitter
Damaged exciter pump
Vibration is turned on
Machine out of infra-red signal range
Operator too close to machine
Communication fault
Remedy
Reduce machine speed, then press vibration
switch.
Check connection; repair or replace as needed.
Repair or replace.
Repair or replace.
Repair or replace.
Repair or replace.
Move transmitter closer to machine.
Move away from machine.
See topic Communication Faults.
Check connection; repair or replace as needed.
Repair or replace.
Repair or replace.
Repair or replace.
Repair or replace.
Repair or replace.
Move transmitter closer to machine.
Move away from machine.
See topic Communication Faults.
Check connection; repair or replace as needed.
Repair or replace.
Repair or replace.
Repair or replace.
Turn off vibration.
Move transmitter closer to machine.
Move away from machine.
See topic Communication Faults.
114
RT / RTx
wc_tx003864gb_FM10.fm